|
IMPRESSION
ADJUSTMENT ARMS
Early in the development process we found it necessary on stations
1 and 2 to modify these arms in order to provide clearance for
the quick-change side frames. Since there was a minimum amount
of material removed, the integrity of these arms was unaffected.
We planned to furnish drawings indicating where to trim the arms
with a band saw. However, after consideration, we feared this
might meet resistance and result in problems. So instead, we decided
to furnish new arms with the necessary clearance. They are included
in the kit along with everything else necessary for installation.
|
FRAME
SPACER REMOVAL OR MOVEMENT
The frame spacer located between stations 1 and 2 and below the
impression cylinder must be removed to provide clearance for the
pneumatic locking system on station 1. Removal of this spacer
is easy and has no effect on the strength of the side frames.
Each Quick Change unit has an in-press frame that mounts permanently
between the side frames. These frames each have 2 spacers that
more than compensate for the removal of a single spacer.
PNEUMATIC
SWITCH MOUNTING
There is a pneumatic switch for each print station that activates
and releases the pneumatic cylinder which locks the station into
position. We have chosen to mount all three on the sheet metal
next to station 3. It is necessary to provide 1/2" diameter
holes for each switch. A template and illustration is furnished.
MOVEMENT
OF ANGLE BRACKET
There is a bracket below the second station that fastens the base
to the outer side frame. This must be moved to the outside to
provide clearance for the roller guides to install or remove station
2.
That's
all there is!
|
